|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: Milling/Drilling G10 Fiberglass posted by Triode_Kingdom on December 13, 2017 at 08:40:55:
I build prototype amps. using Vectorboard and flea clips. But when I have to first cut the board to size and file down the rough edges, I always wear a dust mask until I have washed off the remainder of the material. If the dust gets in my throat it takes a while to clear and is probably dangerous although it's not like asbestos. Just hate it. Same goes for speaker cabs. lined with fiberglass but I add gloves and goggles.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Milling/Drilling G10 Fiberglass - Audio Pete 10:54:45 12/29/17 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
