|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: Any tips for cutting 1.5 inch copper rod? posted by Chip647 on December 13, 2017 at 13:09:20:
I use a band saw for aluminum and copper rod up to an inch or maybe a little more. Above that, I use a cut-off saw. Some of the aluminum rod that I cut for trim rings is almost 4" diameter. It can take 15-20 minutes to slice through that, even with a large cut-off saw. I take frequent breaks to let everything cool down.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Band saw or cut-off saw - Triode_Kingdom 07:38:40 12/14/17 (10)
- RE: Band saw or cut-off saw - used-hifi 09:26:32 12/14/17 (9)
- RE: Band saw or cut-off saw - Triode_Kingdom 10:45:59 12/14/17 (8)
- RE: Band saw or cut-off saw - pictureguy 22:42:38 12/30/17 (0)
- RE: Band saw or cut-off saw - Caucasian Blackplate 20:01:38 12/14/17 (5)
- Flammable cutting fluid? - Mossback 13:08:09 12/15/17 (0)
- RE: Band saw or cut-off saw - vinnie2 05:34:08 12/15/17 (3)
- RE: Band saw or cut-off saw - Caucasian Blackplate 06:27:17 12/15/17 (2)
- RE: Band saw or cut-off saw - Triode_Kingdom 07:43:08 12/15/17 (1)
- RE: Band saw or cut-off saw - used-hifi 08:38:38 12/15/17 (0)
- RE: Band saw or cut-off saw - used-hifi 11:36:48 12/14/17 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
