In Reply to: Band saw or cut-off saw posted by Triode_Kingdom on December 14, 2017 at 07:38:40:
TK for machining aluminum, Oil as in cutting oil is not too good, use plain old rubbing alcohol, what your trying to prevent is chip sticking to the cutting edge, regualr propanol works the best! better then wd40!!
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Band saw or cut-off saw - used-hifi 09:26:32 12/14/17 (9)
- RE: Band saw or cut-off saw - Triode_Kingdom 10:45:59 12/14/17 (8)
- RE: Band saw or cut-off saw - pictureguy 22:42:38 12/30/17 (0)
- RE: Band saw or cut-off saw - Caucasian Blackplate 20:01:38 12/14/17 (5)
- Flammable cutting fluid? - Mossback 13:08:09 12/15/17 (0)
- RE: Band saw or cut-off saw - vinnie2 05:34:08 12/15/17 (3)
- RE: Band saw or cut-off saw - Caucasian Blackplate 06:27:17 12/15/17 (2)
- RE: Band saw or cut-off saw - Triode_Kingdom 07:43:08 12/15/17 (1)
- RE: Band saw or cut-off saw - used-hifi 08:38:38 12/15/17 (0)
- RE: Band saw or cut-off saw - used-hifi 11:36:48 12/14/17 (0)