|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: Any tips for cutting 1.5 inch copper rod? posted by Chip647 on December 13, 2017 at 13:09:20:
How are you using this size rod? Pretty big, for an audio DIY project.
I made some transmission supports out of 1-inch thick steel plates. I took them to a machine shop and they used a 20-ton press brake to cut it. May want to call around your area, for a good machine shop. Esp, if you are not needing to cut this size copper, that often.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- 1.5 inch copper rod. - FenderLover 11:16:52 12/14/17 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
