|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
|
|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: RE: Are Bryston power amplifiers 1 or 2 ohm capable posted by RGA on December 17, 2017 at 03:02:37:
This Accuphase model is marginal for 1 ohm may work without issue , its 3 pr small heat sinks so if you watch temps you maybe OK ...I used to run a pr of 200CX PS audio , prolly one of their better amps ever built , until his current BK series , full copper rails , Gold fuses etc , but had only 3 Prs /Ch and minimal heat sinks for its power ratings, so to run at 2/1 ohm you needed fans. Paul amps are pretty lean in the output stage / Heat sink capacity area , so they are not really rated into low -Z , because of their poor SOA, even his new BK amps are not good low-Z amps...
Regards
Edits: 12/17/17
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Are Bryston power amplifiers 1 or 2 ohm capable - A.Wayne 19:45:47 12/17/17 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
