99.166.174.206
This Post Has Been Edited by the Author
In Reply to: RE: Are Bryston power amplifiers 1 or 2 ohm capable posted by RGA on December 17, 2017 at 03:02:37
This Accuphase model is marginal for 1 ohm may work without issue , its 3 pr small heat sinks so if you watch temps you maybe OK ...
I used to run a pr of 200CX PS audio , prolly one of their better amps ever built , until his current BK series , full copper rails , Gold fuses etc , but had only 3 Prs /Ch and minimal heat sinks for its power ratings, so to run at 2/1 ohm you needed fans. Paul amps are pretty lean in the output stage / Hear sink capacity area so they are not really rated into low -Z , because of their poor SOA, even his new BK amps are not good low-Z amps...
Regards
Follow Ups:
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2017, Audio Asylum, all rights reserved ]
[ Take5 ]