|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: RE: No, I do understand the transient vs continuous condition. posted by gusser on September 19, 2017 at 08:49:09:
"A continous signal with an open secondary is not an issue."
But if a probe slips and there's a momentary spike, it's all over. Or if one happens to accidentally touch the input with the amp at full gain, and the output stage clips, look out! Placing a small resistor across the secondary is simply a good precaution. I wouldn't even think about risking my Magnequest outputs for the sake of a stupid 25ยข resistor!
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Don't capitulate on this point! - Triode_Kingdom 12:57:07 09/19/17 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
