|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: RE: Making measurements advice posted by Caucasian Blackplate on September 18, 2017 at 16:43:03:
"Unloaded is OK for just checking DC voltages."Provided you don't send a signal through it. I would short the input jack if testing unloaded.
But what's the harm in putting a 10ohm 1/2w resistor across the outputs?
Edits: 09/18/17 09/18/17
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Making measurements advice - gusser 16:54:03 09/18/17 (13)
- RE: Making measurements advice - Caucasian Blackplate 16:57:59 09/18/17 (12)
- RE: Making measurements advice - gusser 17:03:35 09/18/17 (11)
- A thought... - Steve O 19:53:59 09/18/17 (5)
- RE: A thought... - dave slagle 06:24:11 09/19/17 (4)
- "I see gussers concern"... - Steve O 08:22:16 09/19/17 (3)
- RE: No, I do understand the transient vs continuous condition. - gusser 08:49:09 09/19/17 (2)
- Don't capitulate on this point! - Triode_Kingdom 12:57:07 09/19/17 (0)
- Okey-doke! (nt) - Steve O 09:18:54 09/19/17 (0)
- RE: Making measurements advice - Caucasian Blackplate 17:13:25 09/18/17 (4)
- Look at this! - gusser 17:19:19 09/18/17 (3)
- RE: Look at this! - Caucasian Blackplate 17:21:18 09/18/17 (2)
- OK, then do it. - gusser 17:26:00 09/18/17 (1)
- Absolutely correct - Triode_Kingdom 18:02:26 09/18/17 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
