RE: Question about bi-amping with fixed-gain amps

Amp/Preamp Asylum

Looking for a new Amp or Preamp? If you're after tubes, post over here.

Follow Ups Full Thread

Topic - Question about bi-amping with fixed-gain amps - bystander 10:46:37 05/11/25 (24)

Thanks everyone, and a bit more context - bystander 07:36:44 05/13/25 (5)

Sure it would - E-Stat 08:06:59 05/13/25 (4)

The Mac amps aren't the issue - bystander 08:48:58 05/15/25 (3)

Not an *issue*, but - E-Stat 08:56:57 05/15/25 (2)

Bi-amping an individual speaker only makes sense if using a line level electronic crossover - Chip647 11:23:33 05/15/25 (1)

Well, seems more common when - E-Stat 13:58:46 05/15/25 (0)

Go here - Ozzie 19:29:15 05/12/25 (0)

I used this - Leo loves music 11:02:27 05/12/25 (4)

Yes, I think that would work - bystander 08:50:35 05/15/25 (0)

Do you know what brand pot is used for volume control? n/t - madisonears 18:43:05 05/12/25 (2)

It's hard to tell from the picture - Tre' 07:28:00 05/15/25 (0)

RE: Do you know what brand pot is used for volume control? n/t - Leo loves music 18:55:56 05/12/25 (0)

Like Jonesy - E-Stat 10:48:13 05/12/25 (0)

RE: Question about bi-amping with fixed-gain amps - Jonesy 09:57:53 05/12/25 (3)

RE: Question about bi-amping with fixed-gain amps - MaggiesAndCats 19:24:31 05/12/25 (2)

RE: Question about bi-amping with fixed-gain amps - Jonesy 19:53:12 05/12/25 (1)

Will do - MaggiesAndCats 13:21:17 05/13/25 (0)

"Gain Controls" are just a potentiometer on the amps input - Chip647 06:10:41 05/12/25 (0)

RE: Question about bi-amping with fixed-gain amps - rrikola@hotmail.com 18:40:33 05/11/25 (5)

RE: Question about bi-amping with fixed-gain amps - Chip647 06:16:05 05/12/25 (4)

I don't think that there will be 'no load' outside of the crossover... - MWE 08:33:12 05/12/25 (3)

RE: I don't think that there will be 'no load' outside of the crossover... - Chip647 13:05:23 05/12/25 (2)

I'm not so sure that an amp 'seeing' a very high reactive load is going to have any problems. - MWE 13:16:51 05/12/25 (1)

RE: I'm not so sure that an amp 'seeing' a very high reactive load is going to have any problems. - Tre' 17:26:52 05/12/25 (0)

Follow Ups

RE: Question about bi-amping with fixed-gain amps - Jonesy 19:53:12 05/12/25 (1)

Will do - MaggiesAndCats 13:21:17 05/13/25 (0)

Post a Message!