|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
|
|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
In Reply to: RE: 1.6QR Connection Plate/Cross over posted by Lynxo on October 15, 2010 at 08:10:57:
Try to get a 'ball end' allen wrench. The size? 5/64s if I remember.
Yes, the allen set screws ARE a PIA. Be easy on yourself, the pain only lasts a minute then you
are done with it.
Advert with PICTURE of ball end. Do Not overtorque it or you'll bust it. Spin down, than tighten with the short arm to setscrew.
Too much is never enough
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: 1.6QR Connection Plate/Cross over - pictureguy 09:18:59 10/15/10 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
