|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
|
|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
In Reply to: 1.6QR Connection Plate/Cross over posted by Lynxo on October 14, 2010 at 20:39:17:
I do NOT know the hole diameter.
What I DO know is this::
#6 wire is TOO LARGE to fit without some reduction in size....file or sand paper.....Chart diameter is 0.162". This is a TICK over 4mm=0.1575"
If I'm reading my 1" micrometer correctly, the jumper measures 0.151" and is made from Chrome Plated Steel. Magnepan should be ashamed of themselves.
If I remember correctly, Banana plugs have an OD of 4mm.......
My #6 jumper replacements are EACH 2" long with 90degree bends on each end.....about .625" from end. They fit well with some help, since the wire is simply too large.
4mm wire would be better 'start' material, if available.
Does this do you any good?
Too much is never enough
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: 1.6QR Connection Plate/Cross over - pictureguy 22:56:24 10/14/10 (8)
- RE: 1.6QR Connection Plate/Cross over - Lynxo 08:10:57 10/15/10 (2)
- RE: 1.6QR Connection Plate/Cross over - RickeyM 10:30:18 10/15/10 (0)
- RE: 1.6QR Connection Plate/Cross over - pictureguy 09:18:59 10/15/10 (0)
- RE: 1.6QR Connection Plate/Cross over (WIRE CHART REF) - heavywindlover 07:59:38 10/15/10 (4)
- RE: 1.6QR Connection Plate/Cross over (WIRE CHART REF) - pictureguy 09:24:47 10/15/10 (3)
- RE: 1.6QR Connection Plate/Cross over (WIRE CHART REF) - gregmacknass2@netzero.com 11:33:46 10/15/10 (2)
- RE: 1.6QR Connection Plate/Cross over (WIRE CHART REF) - pictureguy 12:46:24 10/15/10 (1)
- RE: 1.6QR Connection Plate/Cross over (WIRE CHART REF) - Lynxo 21:22:29 10/15/10 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
