|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
|
|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
In Reply to: RE: Can I suggest you try replacing the 6g Cu wire with 24g Cu wire ... posted by pictureguy on October 12, 2010 at 16:54:32:
are trying to lead you in the right direction.
If you are true to your word, at least one day you will see that...
When you do listen to them, do make some effort to control vibrations on such a jumper.
A super simple jumper would be the thin wire, some teflon tape insulation, some sand and some heat shrink.
Put the short magwire with teflon tape in the heat shrink and shrink the tip of one end. Fill with sand leaving some space at the top. Shrink the other tip. In a general sense, it will look like a piece of candy as seen above.
I made one of these for my old Velo sub that had some thing like 2ft of wire for a 1" jumper. Sure it was easier for the cheap labor to install, but come on.
Cut to razor sounding violins
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Andyr and thetintdoctor - Dawnrazor 20:51:10 10/12/10 (4)
- RE: Andyr and thetintdoctor - thetintdoctor 06:59:02 10/13/10 (3)
- RE: Andyr and thetintdoctor - Dawnrazor 20:24:22 10/13/10 (2)
- RE: Andyr and thetintdoctor - thetintdoctor 07:13:05 10/14/10 (1)
- RE: Andyr and thetintdoctor - Dawnrazor 08:39:39 10/14/10 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
