|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
Register / Login
|
In Reply to: Re: No, No, No... posted by Triode_Kingdom on May 1, 2007 at 23:41:41:
'I don't know much about telco wiring. If I had to guess, I'd say it's shielded.'Nope ! All twisted pair for delivery of low speed stuff ; leased lines , PSTN , ISDN ADSL etc . High speed T3/T3/E1/E3/DS3 uses 75 ohm coax , E1 can often be presented as 120 ohm over twisted pairs . Above 34MBPS speed it's fibre optic . Interfaces such as V24/X21/V35 usually have a braid . Lans use UTP , some voice equipment uses the 'balanced asymetrical' I41 interface which is similar to balanced 120 ohm E1 but with an overall foil shield
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: No, No, No... - . 04:53:54 05/02/07 (7)
- Are you sure? No-name . !!! - cheap-Jack 08:10:05 05/02/07 (6)
- Re: Are you sure? No-name . !!! - . 08:48:44 05/02/07 (5)
- Yes, your mouth is full of "nonense" !!! - cheap-Jack 09:10:39 05/02/07 (4)
- 'Yes, your mouth is full of "nonense" !!!' is poor use of the English language (nt) - . 10:09:38 05/02/07 (0)
- oh dear - . 10:08:48 05/02/07 (2)
- Stop show off your codes in "an audio forum", bud. - cheap-Jack 12:11:41 05/02/07 (1)
- Ipods - . 12:32:28 05/04/07 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
