Home ANK AudioKits Forum

ANK AudioKits support forum

[ Follow Ups ] [ Post Followup ] Thread: [ Display  All  Email ] [ ANK AudioKits Forum ]
[ Alert Moderator ]

RE: Kit1 : Replacing the PCB valve board

I've attached a PDF of the layout I used. The board is to scale (yes it's smaller than the original) though as I found out the valve base positions and screw holes are not perfectly measured. I used rubber grommets between the case and the pillar which gives a little flexibility and isolation. I then mount the board to the pillars. Wherever possible components are directly wired to the valve base.

Colours on the PDF are used only to avoid confusion where lines cross and the layout was used as a guide only.

This post is made possible by the generous support of people like you and our sponsors:
  Schiit Audio  

Follow Ups Full Thread
Follow Ups
FAQ

Post a Message!

 Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.

[ Top Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2025, Audio Asylum, all rights reserved ]
[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]