Home ANK AudioKits Forum

ANK AudioKits support forum

[ Follow Ups ] [ Post Followup ] Thread: [ Display  All  Email ] [ ANK AudioKits Forum ]
[ Alert Moderator ]

RE: Kit1 : Replacing the PCB valve board

Thanks Bill. Certainly an improvement. OK - not the prettiest board ever built I'm sure. I forgot to mention that I also isolated the board on rubber gromets. OK, that was partly to mke it easier to get the valve bases to match up to the case holes, but it also does reduce vibration.

This post is made possible by the generous support of people like you and our sponsors:
  Schiit Audio  

Follow Ups Full Thread
Follow Ups
  • RE: Kit1 : Replacing the PCB valve board - RhythMick 00:49:32 12/03/07 (0)
FAQ

Post a Message!

 Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.

[ Top Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2025, Audio Asylum, all rights reserved ]
[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]