ANK AudioKits Forum ANK AudioKits support forum

---

[ Follow Ups ] [ Post Followup ] Thread: [ Display  All  Email ] [ ANK AudioKits Forum ]

---

[ Alert Moderator ]

---

RE: ANK1 - 300B Bypass cap

Posted by GTCharlie (A) on November 9, 2007 at 23:54:31

In Reply to: RE: ANK1 - 300B Bypass cap posted by RhythMick on November 9, 2007 at 08:59:00:

I assume you're using the standard 900 ohm cathode resistor in the schematics. The 50uF or so reduction in by-pass cap will have minimal impact. The voltage there should be in vicinity of 75-80v, so 150v up should be very safe. Now if you were to alter bias ... that would be a different story. IME, you'd have better result by-passing that 220uF/200v WK with a small polyprop - Hovlands come to mind, or Audio Note's copper foils. Say 0.02uF. Enjoy the weekend...

This post is made possible by the generous support of people like you and our sponsors:

Schiit Audio

---

[ Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2025, Audio Asylum, all rights reserved ]

---

[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]

---