ANK AudioKits Forum ANK AudioKits support forum

---

[ Follow Ups ] [ Post Followup ] Thread: [ Display  All  Email ] [ ANK AudioKits Forum ]

---

[ Alert Moderator ] [ Edit ] [ Delete ]

---

Re: Fitting BGs on the DAC board

67.84.115.94

Posted by Kit-1 on August 4, 2006 at 04:37:40

In Reply to: Re: Fitting BGs on the DAC board posted by Vincin on August 3, 2006 at 21:10:56:

Hello Vincin,

Best thing to do is actually measure the voltage at the cap before replacement. I believe all of the AN DAC boards are similar in that all caps "see" 5vdc, but it would be best to check before replacing the cap. A 6.3v cap is fine in a 5v circuit (+20% overrated). I replaced all mine (DAC 3.1x) w/ BG-N High Q in Super E cap, which sounds similar to what you'll be doing with the N's. Just remember to wire them long lead to short lead, and vise versa for Super E. I found it easiest to wire one cap to the top of the board and the other below the board, perpendicular to the top cap.

have fun!

This post is made possible by the generous support of people like you and our sponsors:

Kimber Kable

---

[ Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2025, Audio Asylum, all rights reserved ]

---

[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]

---