|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
|
|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: RE: Would adding an exterenal 47K load through the phono bring it on? posted by SchoolOfRock on September 26, 2017 at 08:20:56:
If you look at the schematic, the 49.9kohm resistor is *soldered* to the PCB. It is the other values that are connected in via the switch.
It is 99.9% chance that the input JFETs have gone bad. As long as the local dealer can get the correct part from Audio Research, this will be the way to go. I would guess this will cost around $200, as most shops are aroun $100 per hour. Good luck!
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Cleaning the switch won't help - Charles Hansen 18:04:57 09/29/17 (1)
- RE: Cleaning the switch won't help - SchoolOfRock 10:21:24 09/30/17 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
