|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
|
|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: RE: Tube amp output impedance and speaker impediance posted by airtime on September 26, 2017 at 09:12:43:
Yes. In that case it becomes an essentially meaningless number, doesn't it? :) "Damping Factor" is not only a misnomer, but an often misunderstood parameter specified in amplifier spec sheets.
It would be preferable if amplifier manufacturers simply specified the output impedance (directly) in ohms. And also specify any deviation with regard to frequency....if there is one.
Dave.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Tube amp output impedance and speaker impediance - Davey 09:21:42 09/26/17 (1)
- RE: Tube amp output impedance and speaker impediance - hahax@verizon.net 14:17:52 09/26/17 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
