![]() |
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: If it's for your Maggies - do you think you have much of a chance to listen to these amps in Class A? N/T posted by carcass93 on September 28, 2013 at 07:59:34:
Most of the listening with any speaker will be in class A. Even a speaker with 80 db efficiency(very low)will be at well over 90 db with 35 watts. Only very short term peaks will go out of class A and you won't notice that unless you drive the amplifier into clipping.
By the way, technically this is not a class A amp. It is a rich AB amp. A true class A amp stays class A into clipping at any load. But that's rare. Perhaps one of the few amps that was class A that way was the 25 watt Levinson ML2 that was still class A into 2 ohms where it put out 100 watts. But this amp is effectively a 35 watt class A amp into 8 ohms.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: If it's for your Maggies - do you think you have much of a chance to listen to these amps in Class A? N/T - hahax@verizon.net 20:08:11 09/28/13 (11)
- RE: If it's for your Maggies - do you think you have much of a chance to listen to these amps in Class A? N/T - iqaudiocorp@gmail.com 14:04:41 10/07/13 (0)
- Typical solid state amps have highest distortion at lowest levels - Feanor 05:24:13 09/29/13 (9)
- I believe you are wrong... - rlw 08:03:28 09/29/13 (4)
- RE: I believe you are wrong... - pictureguy 21:30:59 10/02/13 (2)
- Nowhere has your tag line seemed more appropriate than here. - axolotl 22:23:13 10/02/13 (1)
- RE: Nowhere has your tag line seemed more appropriate than here. - pictureguy 09:10:28 10/06/13 (0)
- No: here is what Emotiva says ... - Feanor 08:21:30 09/29/13 (0)
- RE: Typical solid state amps have highest distortion at lowest levels - hahax@verizon.net 07:33:28 09/29/13 (3)
- The typical AB amp has a low bias setting ... - Feanor 08:26:02 09/29/13 (2)
- RE: The typical AB amp has a low bias setting ... - hahax@verizon.net 10:28:13 09/29/13 (1)
- RE: The typical AB amp has a low bias setting ... - bigshow 17:29:51 10/06/13 (0)