|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
|
|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
In Reply to: Since we're comparing apples to apples...here's my K2 specs.... posted by kootenay on September 22, 2010 at 12:05:40:
that I'm using to drive my Thiel 3.6 in my dedicated listening room.
ARC D-250 MKII Servo: Power output 240 watts per channel minimum continous power (both channels operating) at 16 ohms from 20Hz to 20kHz with less than 1% total harmonic distortion (typically below .005% at one watt output)
Power bandwidth: 250 watts per channel minimum continuous into 16, 8, 4 ohms from 20Hz to 20kHz with less than 1% THD at rated output and below .005% at 1 watt.
Input sensitivity: .8V RMS for rated output.
Input impedance: 80 kOhms
Power supply energy storage: 550 joules
Power requirements: 105-125VAC, 2000 watts (20 amps), 900 watts at "idle".
Tube complement D-250: (6) 6922, (4) 7119/7044, (8 matched pairs) 6550, (4) 6550, (2) 12AT7
Dimensions: 19" W (rack panel) x 10.5" H x 20.75" D (does not include rack handles, front or back)
Weight 120 lbs. Net, 155 lbs. Shipping
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- On the side note.....here's the specs of the tube amp.... - kootenay 12:12:47 09/22/10 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
