|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
|
|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
In Reply to: RE: Amplification is likely just fine... posted by BigguyinATL on September 21, 2010 at 20:20:25:
That I'm using right now to drive my Martin Logan Quest speakers in my dedicated HT room.
Specifications:
500 Wpc @ 8 ohms
800 Wpc @ 4 ohms
1,250 Wpc @ 2 ohms; in all cases with both channels driven to 0.1% or less THD
Damping factor: >3000 from 10 to 400 Hz
Signal to Noise: greater than 110 dB below full rated bandwidth power
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Since we're comparing apples to apples...here's my K2 specs.... - kootenay 12:05:40 09/22/10 (4)
- Opinion? - mrr 15:11:16 09/22/10 (2)
- The Hafler amp that you're looking at.... - kootenay 22:26:59 09/22/10 (1)
- RE: The Hafler amp that you're looking at.... - mrr 08:44:23 09/23/10 (0)
- On the side note.....here's the specs of the tube amp.... - kootenay 12:12:47 09/22/10 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]