|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
|
|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
In Reply to: Plan "B" posted by RickeyM on August 26, 2010 at 07:37:05:
You could cut a hole in the bottom of the box, just big enough to accommodate an extra deep cavity for the cap. Small square of 1/8" plywood with wood spacer pieces, all glued together to make it. Close to the center, just don't go to the edge corner of the box. Then you can add some feet to the bottom, that will raise the entire existing box higher than the added cavity. Done right, it wouldn’t be seen from above. Something MacGyver would do :^).
Edits: 08/26/10
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Plan "B" - johnvb 09:00:40 08/26/10 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
