Tweakers' Asylum

• RE: Whatever the problem now is - twl168 18:54:14 01/06/08 (2)
  In Reply to: RE: Whatever the problem now is posted by analog_sa on January 06, 2008 at 05:59:52

  Hi Thanks.
  
  A connector did come loose afterward. It is the pin that connect the motor unit. But previously this was not the issue. I made the connector loose after going back to check and accidentally break the solder point.
  
  Now, I can not re-solder the pins back because the circuit board will not allow solder to bind any more. Can you please help to let me know what to do in this case to re-solder the pin back.
  
  I guess my solder iron is too high temperture and melt the circuit board.
  
  Thanks you for your help.
  
  

  ---

  • RE: Whatever the problem now is - analog_sa 09:53:46 01/07/08 (1)
    In Reply to: RE: Whatever the problem now is posted by twl168 on January 06, 2008 at 18:54:14

    Hi
    
    Sorry, i didn't quite get the current state of affairs. Can you email me a pic?
    
    Btw, no amount of heat can melt the PCB. It's easy to lift tracks though
    
    

    ---

    • RE: Whatever the problem now is - twl168 10:09:57 01/07/08 (0)
      In Reply to: RE: Whatever the problem now is posted by analog_sa on January 07, 2008 at 09:53:46

      The problem is lift tracks or lift trace on the pcb board. As others suggested, I guess my best option is to run wire directly to the other end of the track to reconnect.
      
      Thank you for your help
      
      

      ---

Post a Followup:

This post is made possible by the generous support of people like you and our sponsors:

Parts Connexion

---

[ Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2025, Audio Asylum, all rights reserved ]

---

[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]

---