|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
98.59.249.131
In Reply to: RE: CCS study in depth, what do you think this approach posted by Eric Chan on April 25, 2024 at 23:25:46
It depends on what is causing the glare. If it is transient oscillation (as is common with high transconductance tubes such as the 6DJ8 family) then you are buffering the plate and would connect at the other end.
Follow Ups:
I have got the reply from NAZ,saying to use big R as much as possible, but I intend to use as driver, swinging 100V p to p needed, so what appropriate value the R should be, if it is plate stopper, normally 100 ohm can do
"Hi Eric,
It depends on the operating points you use but only in as much as I would use as high a value as you can that still allows your chosen operating points. Eg, if you were operating the tube at say 300V B+ and wanted a plate voltage of say 120V at say 15mA you could use a 10K plate resistor. This would drop 150V, leaving a 30V drop across the CCS. Of course, this would only be OK for max AC swings of around 20V on the plate but if this needed to be higher, say for a driver stage then you would use a lower value plate resistor to allow greater head room for the CCS..
As I mentioned, the plate resistor is not technically required at all with a suitable CCS but IME it definitely sounded better with the FETs I have tried. The way I look at it this gives you the best of both worlds in that the CCS provides the high impedance load that tubes want for the lowest possible distortion and the resistor shields against the often harsh traits of FETs
I have no theory, and thus no idea what the value "should" be.
I have used 220 ohms at the plate, as a precaution, with 6922s at 70v/4mA. But I did not try without it, so I don't know whether there was a problem without them. The circuit also used 220 ohm grid stoppers as precautions.
Hi Paul,
Then what would be the value for this buffer R, if I intend to use this stage as driver stage, swinging 100V P to P, I was told on such case it cannot use high value of R limiting the swing
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: