![]() ![]() |
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
75.24.119.95
Hi,
Are there any situations where it would be better to use a polyester cap
over a polypropylene cap in an audio circuit?
Regards
Ned
Follow Ups:
Ned, I used to be a polyprop fan only. As a single cap, they do sound better (unless you go to teflon). Problem is when you use a bunch of them, they sure lean the sound out. as one poster suggests, use paper and oil. I use a mix of paper and polyester to make sure the sound does not get to lean. Nothing like getting done with a bunch of work on a piece, you break it in, sit down to listen to it, and ear fatigue sets in after 20 min.
best
john
paper in oil rather both of those for coupling..Take a read here.
Hi.
Technically, the E/H hysteresis curve of PET (polyester, or polyethylene
terephthalate) is very slightly less linear than PP, but is already much better than mica, & low voltage ceramic.
I've used PP in hi-pass filters in loudspeaker X-over networks & signal paths where space is available. But for large cap values up to 10uF & low DC voltages, & space is not available, I've used PET (aka Mylar) as coupling caps in my tube & SS amps, even for the crucial phonostage I/P & O/P coupling.
Sound pretty OK & PET is much cheaper than PP of the same large capacitance.
c-J
PS: FYI, paper in oil caps is most linear but really good ones cost a fortune.
Polypropylenes are usually 50% bigger than the equivalent mylar caps. Imprtant where space is at a premium.
Stu
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: