|
Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ. |
|
|
|
Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ. |
|
In Reply to: New DIY Roller Blocks posted by srenoch1@yahoo.com on June 14, 2010 at 15:39:52:
concave chrome over cast zinc, pull, chrome steel ball, rope caulk, fender washer + machine screw and CAE damping square applied to bottom of rosette. Maybe it was the very light kiln dried maple which just did not dance well with the signal for me.I experimented with more variations based on found junk... same pulls mated to steel nylocks filled with caulk, machine screw & fender washer things got better. I could 'tune' them by placing them on cutting board or thick arcylic.
Mated to aluminum urethane scooter wheel with a ring of CAE self adhesive damping on the bottom. This recipe had the best balance detail-warmth. I still use 'em here and there.
Fun stuff! Nice work BTW.
sincerelybeanz
Edits: 07/09/10
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- I started with something very close to yours - clbeanz 17:19:51 06/15/10 (2)
- Cool lookin'. How do they skate? nt - bartc 21:36:10 06/15/10 (1)
- RE: Cool lookin'. How do they skate? nt - clbeanz 14:57:54 06/16/10 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
