RE: Correct Voltage

Posted by Coner (A) on March 9, 2010 at 16:51:41

In Reply to: Correct Voltage posted by Marc Almirall on March 9, 2010 at 14:22:05:

Depends on the mfr's. preference, I'm sure they design the
product to take 120-125 max. anyway (or they should). I would
not lose any sleep here, you're fine. But they're are step down's
out there, I have one that I found at a Goodwill store, but I
don't use it....well maybe on a slide projector, I think it's
90-100V out, not sure.

If you're actual measured line voltage is much over 120V, you might
check into your local power co. about changing the voltage tap
on the street tranny to a lower V.

This post is made possible by the generous support of people like you and our sponsors:

Follow Ups Full Thread

Topic - Correct Voltage - Marc Almirall 14:22:05 03/09/10 (18)

RE: UPDATE - Marc Almirall 14:28:50 04/02/10 (0)

Chinese Amp? - Awe-d-o-file 11:21:36 03/11/10 (4)

RE: Chinese Amp tester - Craiger56 10:33:14 03/12/10 (0)

RE: Chinese Amp? - Marc Almirall 17:55:51 03/11/10 (2)

RE: Chinese Amp? - Dynaudio_Rules 14:31:33 03/12/10 (0)

Here is one, but it might be too small. - Al Sekela 12:15:03 03/12/10 (0)

RE: Correct Voltage - wheezer 10:25:29 03/11/10 (1)

RE: It's a tube amp. (nt) - Marc Almirall 12:12:40 03/11/10 (0)

Try it and see. - Al Sekela 16:03:54 03/10/10 (5)

RE: Try it and see. - Marc Almirall 17:36:39 03/10/10 (4)

"DC on the AC" can cause transformer hum. - Al Sekela 15:49:41 03/11/10 (3)

RE: "DC on the AC" can cause transformer hum. - Marc Almirall 17:59:55 03/11/10 (2)

PS Audio Humbuster III or DIY - Al Sekela 11:56:38 03/12/10 (0)

RE: "DC on the AC" can cause transformer hum. - Marc Almirall 18:02:52 03/11/10 (0)

RE: Correct Voltage - wheezer 20:03:55 03/09/10 (0)

RE: Correct Voltage - rwiley 19:23:32 03/09/10 (0)

RE: Correct Voltage - Coner 16:51:41 03/09/10 (1)

RE: Correct Voltage - Marc Almirall 17:32:21 03/09/10 (0)

Follow Ups

RE: Correct Voltage - Coner 16:51:41 03/09/10 (1)

RE: Correct Voltage - Marc Almirall 17:32:21 03/09/10 (0)

RE: Correct Voltage

Post a Message!