|
Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ. |
|
|
|
Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ. |
|
In Reply to: Since this is the DIY forum posted by Mark Kelly on October 17, 2005 at 16:55:41:
Hmmm. Not sure I can see pulling that off for a tool that will be used on eyelets as small as these.Here's what the "proper" forming tool and anvil look like:
You can see that the "flare" on the forming tool is concave, not convex. Also the pin on the anvil tool is spring loaded to allow it to be displaced by the pin on the forming tool as the eyelet is pressed.
Keep in mind that the eyelets I plan to be using will have an ID of between 0.02 and 0.035.
se
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Since this is the DIY forum - Steve Eddy 18:08:58 10/17/05 (6)
- Yikes! - Mark Kelly 04:20:41 10/18/05 (5)
- Yeah. :) - Steve Eddy 10:04:25 10/18/05 (4)
- Re: Yeah. :) - alan m. kafton 11:04:26 10/18/05 (3)
- Re: Yeah. :) - Steve Eddy 13:02:10 10/18/05 (2)
- Re: Yeah. :) - alan m. kafton 16:04:25 10/18/05 (1)
- Re: Yeah. :) - Steve Eddy 16:14:52 10/18/05 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
