![]() ![]() |
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
68.63.205.115
In Reply to: RE: Hickok 6000 Basic Tube Testing posted by srivenkat on February 15, 2010 at 18:25:02
Hi Sri,
The Quality Test is a preliminary good/bad test. To perform this test set the shunt dial to the number given on the roll chart. This test is not meant to give you a micromhos reading.
If you want to know the micromhos readings, set the shunt dial to the appropriate red dot. So if the average new reading on the roll chart is less than 3000 set it to the dot near 73 on the shunt dial and so on.
Hope this helps, let me know if you have additional questions.
Follow Ups:
Hello Tom
Thanks a lot for your detailed instructions. This really helps, I do have the manual but it was bit confusing to follow. Its very clear from your explanation.
Thanks again.
-Sri
Post a Followup:
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: