Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders.

---

[ Follow Ups ] [ Post Followup ] Thread: [ Display  All  Email ] [ Tube DIY Asylum ]

---

[ Alert Moderator ]

---

RE: Voltage Max of Holco H4P Resistors?

Posted by Chris O on September 28, 2009 at 07:35:46

In Reply to: Voltage Max of Holco H4P Resistors? posted by tvr2500m on September 27, 2009 at 21:07:52:

I have always made sure that the drop across any given Holco was less than 100 volts. I have used them with a fairly high absolute voltage but with a small drop and they worked just fine. The problem they have is that they cannot take heat. Do not use them as plate load resistors.

This post is made possible by the generous support of people like you and our sponsors:

Atma-Sphere Music Systems, Inc.

---

[ Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2025, Audio Asylum, all rights reserved ]

---

[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]

---