|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: good push pull 2A3 design schematic posted by vinnie2 on September 17, 2017 at 07:33:22:
Vinnie if you can spend a little money now might be a good time to pick up a couple of interstage transformers. In a push pull they do 4 things I really like: choke load, low voltage drop, phase splitter, and no coupling cap.
Not sure if Dave below is using that set up on his pp 300b but he could wind you some killer units to get the job done with various tubes so you could bread board different amps. On the cheap Hammond makes some units which Andy has played with some success.
Audio design guide on the web has a ton of schematics. Look at the parts count on a interstaged 2 stage pp amp. You could clip board one up in a few hours. Keep up the good fight.
Enjoy the ride
Tom
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: good push pull 2A3 design schematic - TomWh 14:59:56 09/17/17 (6)
- RE: good push pull 2A3 design schematic - vinnie2 18:24:59 09/17/17 (5)
- RE: good push pull 2A3 design schematic - Triode_Kingdom 05:47:21 09/18/17 (4)
- RE: good push pull 2A3 design schematic - vinnie2 07:02:06 09/18/17 (3)
- RE: good push pull 2A3 design schematic - Triode_Kingdom 08:11:18 09/18/17 (2)
- RE: good push pull 2A3 design schematic - vinnie2 09:44:16 09/18/17 (0)
- RE: good push pull 2A3 design schematic - vinnie2 09:25:32 09/18/17 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
