|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: RE: Do your voltages somewhat match the schematic? (nt) posted by vinnie2 on June 21, 2017 at 13:42:38:
Measure in sections: Get the power supply stable, then install and measure the the front-end/driver section, then plug in and measure the output tubes. It will help you nail down the problem.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Do your voltages somewhat match the schematic? (nt) - Chip647 14:14:53 06/21/17 (2)
- RE: Do your voltages somewhat match the schematic? (nt) - vinnie2 08:03:58 06/22/17 (0)
- RE: Do your voltages somewhat match the schematic? (nt) - vinnie2 17:28:23 06/21/17 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
