|
OTL Asylum OTL, Output Transformerless Amplifier User Group. |
|
|
|
OTL Asylum OTL, Output Transformerless Amplifier User Group. |
|
In Reply to: Never mind. Using monoamps leaves me without enough channels of amplification. posted by jeffreybehr on December 17, 2017 at 11:36:07:
How does one 6SL7 "drive" 5 channels of output? Or did you mean to say that each channel uses a single 6SL7 as a driver? I am totally unfamiliar with Butler amplifiers. I would have assumed they were all solid state until you mentioned the 6SL7. Anyway, driving a 4-ohm, 86-db speaker with an MA1 is asking a lot from the amplifier and probably not the way to get the best out of it. Assuming the Butlers have a very low output impedance and lots of power per channel, you're probably better off with them.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Never mind. Using monoamps leaves me without enough channels of amplification. - Lew 14:32:52 12/17/17 (1)
- Yes, "one soldered-in 6SL7 per channel as drivers". - jeffreybehr 19:04:04 12/17/17 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
