|
OTL Asylum OTL, Output Transformerless Amplifier User Group. |
|
|
|
OTL Asylum OTL, Output Transformerless Amplifier User Group. |
|
In Reply to: RE: Atma-Sphere S30 with a passive pre-amp posted by fred.hammersmith@videotron.ca on May 9, 2008 at 06:41:34:
Usually you want a lower impedance and 10K is a good value. The problem is that with a passive, the 10K is the impedance that your source will have to drive. It might not be so happy with that, so then you have to run a higher resistance in the passive, which can be troublesome for interconnect control.
In your case you are avoiding this (I assume) by running your control at a higher setting all the time, on account of your source is only 2 volts. So I would not worry about it if what I just said is true.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Atma-Sphere S30 with a passive pre-amp - Ralph 13:16:45 05/09/08 (1)
- RE: Atma-Sphere S30 with a passive pre-amp - fred.hammersmith@videotron.ca 13:46:24 05/09/08 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
