Seeking recommendation for cleaning AN Tx copper shrouds

ANK AudioKits Forum

ANK AudioKits support forum

The output transformers I ordered through PCX for my 300B monoblocks arrived with what appears to be a clear coat type seal over very "dirty looking" dark spots covering the copper shrouds. . . It's as though the dirt, grease and grime was "sealed in" to avoid oxidation . . .

Anyone dealt with this issue and willing to share their cleaning strategies? Chemicals needed, etc.

I need to remove what appears like a clear sealant, clean the copper shrouds, then properly re-seal to avoid oxidation . . . for what they charge for these I am surprised they were sent in such bad shape . . .

If they weren't sitting on top of my amp chassis in clear sight I probably wouldn't worry about it but they are huge and sit on top so clearly will be seen and therefore I would like them to look good. . .

(the photo is not very clear but it somewhat shows the spots)

Thanks,

M-

This post is made possible by the generous support of people like you and our sponsors:

VH Audio

Topic - Seeking recommendation for cleaning AN Tx copper shrouds - Audionorth 18:00:19 11/13/10 (5)

RE: Seeking recommendation for cleaning AN Tx copper shrouds - scarebus 18:22:40 11/17/10 (4)

My experience with this issue - Audionorth 20:48:30 11/17/10 (3)

A better looking piece of copper - Audionorth 11:30:10 12/04/10 (2)

RE: A better looking piece of copper - scarebus 20:34:13 12/08/10 (1)

RE: A better looking piece of copper - Audionorth 21:50:54 12/08/10 (0)

FAQ

Post a Message!

Forgot Password?

Moniker (Username):
Password (Optional):
	Remember my Moniker & Password (What's this?) Eat Me
E-Mail (Optional):
Subject:

Message:	(Posts are subject to Content Rules)

Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:	Automagically notify you when someone responds.

To view your new posting or follow-up, click on the RELOAD or REFRESH button on your browser.