In Reply to: Wiring vol pot on L3 posted by Paul Folbrecht on April 11, 2009 at 09:34:51:
hello Paul
My manual is also not complete i miss the last 20 pages
i did not get it and sent many email als parts are missing .
On the pot is mounted on a pcb there is written 1n out and gnd
if you hold the pot and look at the back of the pcb hold GND up
onthe left you see out and in is then under.
From the 5687 board Lin go's to the upper out and Rin go's to the lower out
the yellow intelink cable go's from the right side of the input to the
right in on the pot
and the left side go's to the left side
this is all seeing from the back of the pot
all ground cables must connected at GND it doesnt matter where
Robert
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Wiring vol pot on L3 - horny 03:11:05 04/12/09 (1)
- RE: Wiring vol pot on L3 - horny 08:36:18 04/15/09 (0)