ANK AudioKits Forum ANK AudioKits support forum

---

[ Follow Ups ] [ Post Followup ] Thread: [ Display  All  Email ] [ ANK AudioKits Forum ]

---

[ Alert Moderator ]

---

RE: TRANS300 Burn In

Posted by rodge827 (A) on September 22, 2008 at 18:36:43

In Reply to: TRANS300 Burn In posted by ClarKit on September 22, 2008 at 02:49:43:

I put a pair on my amps back in June. I was told to run them for a couple of hundred hours at high listening levels to get as much current through them as possible. At first I experienced what you did. My amp puts out 8 watts so I picked up a couple of 20 watt 8 ohm resistors at Radio Shack, removed the speaker wire from the speaker, and attached the resistors to the speaker wire. Turned up the volume and let the system run 24/7 with the Isotek burn in disk. After about 10 days the speaker wire went back on the speakers and YES a BIG improvement across the board. Bass control was better, highs were sweeter, mids were more natural. Your in for a treat!!
"Too clever is dumb"... Ogden Nash

This post is made possible by the generous support of people like you and our sponsors:

Atma-Sphere Music Systems, Inc.

---

[ Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2025, Audio Asylum, all rights reserved ]

---

[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]

---