|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
|
|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: RE: Full blown Kal Rubinson review and in depth JA measurements.... posted by Ric Schultz on December 11, 2024 at 20:59:41:
Ric, I posted the link below to what I believe is the Buckeye page for their Purifi 1ET9040BA based monoblocks. Scroll down to the Custom I/O Board: heading where he lists the TI OPA1656 OP Amp.[EDIT]: Even the Purifi 1ET9040BA PDF data sheet is a bit confusing. It shows the module gain as 14.4 dB so you're left to assume that the overall gain is due to the op-amp input which has 3 settings. The datasheet also shows the module input Z as 1.5kOhm diff & 1.3kOhm single-ended. I have to assume that the higher input Z in some reviews (and your finding) is from the input of the op-amp and I further assume that it will vary depending on what input resistor values the builder chooses to use??? Big question mark. Do you know how they come up with the real input Z because it's not clear to me.
Edits: 12/12/24 12/12/24 12/12/24
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Full blown Kal Rubinson review and in depth JA measurements.... - AbeCollins 07:20:16 12/12/24 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
