|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
|
|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: RE: B & K ST-140 Filter Caps posted by Uncle Mike on October 7, 2020 at 03:55:18:
the size & quality of the caps i.e. where they were made etc. is most important so they last a good while. Increasing the capacitance too much might also put too much strain on the PS diodes at startup.
I've seen many people replace PS caps and declare a complete makeover to the amp with the new caps. Don't forget to buy reputable ones and a good break-in time to evaluate them. I'm also not familiar with who makes caps today in the size you need that are as dependable and well made as the older U.S. Sprague's.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- I agree with Mikey - Story 04:37:42 10/07/20 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]