Home Planar Speaker Asylum

Welcome! Need support, you got it. Or share your ideas and experiences.

warning... long and wordy answer... sorry

Many years ago I had replaced my failing EHT boards with ones that Kent was making and selling at the time. The design was based on the then current 988's. A few weeks later, Kent sent me some 100K +/- 1% resistors to swap out of that design in order to reduce the bias voltage a tad. Well, I totally forgot about them until recently dealing with Kent on having a bass panel sent in for repair. He reminded me about the resistors, and boy, what a difference it made when I made the switch. I'd gone all these years... well, you get the picture. Anyways, the resistor is located at the far edge of the EHT board. Unfortunately I can't find a picture on the net. And I don't recall what resistor it replaced. I believe it was just an initial batch he did back then, and then reached out with a resistor value he felt would work better, and currently uses on his boards.

Cheers!

Jonesy


"I know just enough to get into trouble. But not enough to get out of it."




This post is made possible by the generous support of people like you and our sponsors:
  Kimber Kable  


Follow Ups Full Thread
Follow Ups

FAQ

Post a Message!

Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.