|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
|
|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
In Reply to: RE: I don't understand the directions. posted by ahendler on April 16, 2015 at 14:18:28:
I think you can start from ahender's list and tweak from there. Not every room that can handle the Limage setup successfully will actually do that "cathedral" effect. When tweaking start with tweaking the position from the front wall (the one you are facing) bringing the speakers up nearer to you in small increments of 1" or so, just keep the speakers perpendicular to the sidewalls and at the same distance. You should reach a point where the soundstage "snaps together" and where further advancing the speakers makes the effect fall apart. You can try then to see if you get the "cathedral effect" while doing your "monkey walk" or scooting too and fro on a skateboard.
When you are done with that then go on to balancing the bass by reducing the width of the slot between the wall and the panel to increase bass and pulling away from the sidewall to reduce bass.
When this is done you can try to increase image precision with minor toe in.. If any is needed it will still likely be less than 1".
If you have the slightest reason to suspect that your floors are uneven then use a bubble level to guide you to set the speakers vertically. The slightest departure from vertical will damage or even entirely scramble the soundstage and give you lopsided height cues..
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: I don't understand the directions. - Satie 15:35:59 04/16/15 (1)
- RE: I don't understand the directions. - r3332698049 03:37:00 04/25/23 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
