Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences.

---

[ Follow Ups ] [ Post Followup ] Thread: [ Display  All  Email ] [ Planar Speaker Asylum ]

---

[ Alert Moderator ]

---

RE: mg20r buzzing, is it aluminum wire? how to pull socks?

Posted by macmagman (A) on September 6, 2014 at 11:29:30

In Reply to: mg20r buzzing, is it aluminum wire? how to pull socks? posted by Blaine H on September 5, 2014 at 16:06:47:

I'm not sure on the 20's if you have access to the mid panel but if your buzz is coming from the bass the only alternative would be to send them back to Magnepan for replacement. They will NOT send you the panels till they have your old ones, I tried. The midrange in one of my 20.1's went out and that was my only alternative.

I did take mine apart and sent them only the panel, saved a ton on shipping and they aren't that hard to remove. I think the cost of the new panel was about $1400.00. If I were you I would send both of them and see if they will upgrade them to 20.1 panels, then for around 3K or so you will have a new set of 20.1's, as long as the new panels will fit into the existing frames.

This post is made possible by the generous support of people like you and our sponsors:

Atma-Sphere Music Systems, Inc.

---

[ Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2025, Audio Asylum, all rights reserved ]

---

[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]

---