Home Planar Speaker Asylum

Welcome! Need support, you got it. Or share your ideas and experiences.

easy solution

if I were to do it over again with MG1.6's I wouldn't rip or tear the sock, or 'gut' the crossover well like I did last time.

I'd first unstaple the bottom, then undo the terminal plate. I'd then simply remove the spades connected to the pushtabs leading to the drivers. All you'd have to do at this point is thread the new crossover leads into the exsiting push tabs (there's even actually a hole in each tab to thread).

If you then decide to sell the panels in their original form you'd simply reverse this process without compromise.










Edits: 09/07/12 09/08/12

This post is made possible by the generous support of people like you and our sponsors:
  Parts Connexion  


Follow Ups Full Thread
Follow Ups

FAQ

Post a Message!

Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.