|
Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
Register / Login
|
|
|
Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
Register / Login
|
In Reply to: Re: Would you recommend it for a table with a ceramic or teflon bearing? (nt) posted by nsgarch on April 17, 2007 at 12:48:30:
The shaft (inner bearing) and outer bearing wall is metal, the thrust pad at the top (it is inverted) is teflon, and the ball is ceramic. The instructions for the table tell me to place the oil in the upper oil bath of the inner bearing where the ceramic ball will sit and let it run over so it drips down along the bearing wall into the lower oil bath. Then the outer bearing slips over the inner bearing.Pictures are are in the link below, just scroll down the page.
Sounds like it would work. I also see VdH offers another oil, the TLF Type II which may work as well.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Would you recommend it for a table with a ceramic or teflon bearing? (nt) - clio09 15:11:19 04/17/07 (2)
- Re: Would you recommend it for a table with a ceramic or teflon bearing? (nt) - nsgarch 15:44:26 04/17/07 (1)
- Thanks, I'll look into it... - clio09 18:43:31 04/17/07 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
