Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ.

---

[ Follow Ups ] Thread: [ Display  All  Email ] [ Tweakers' Asylum ]

---

[ Alert Moderator ]

---

Re: Easy DIY

Posted by StevenACNJ (A) on December 26, 2002 at 03:39:31

In Reply to: Easy DIY posted by Roger Hill on December 25, 2002 at 07:22:42:

Thanks Roger,

I started drawing it out on paper for the center channel. This is the easier channel because it is only one board. The front speakers have two boards each.

I think I am starting to see the light. When I look at the bottom trace side of the pc board there are thin dark green lines that outline larger areas of lighter green. The thin dark green lines do not pass current and the larger lighter green areas have copper underneath and pass current on to any component soldered to that area. Is this correct?

Also the current is flowing from the binding post end of the board to the opposite end. So if a speaker lead is attached first toward the binding post side even if there is lets say a resistor in the same trace but is attached after the lead wire - that lead is not being effected by the resistor?

I am also assuming that the red binding post is the + lead and black is the - lead.

Thanks

This post is made possible by the generous support of people like you and our sponsors:

Parts Connexion

---

[ Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2025, Audio Asylum, all rights reserved ]

---

[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]

---