|
Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ. |
|
|
|
Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ. |
|
In Reply to: Shunt mod to Volume pot, did I got it?? posted by Chuck T on November 20, 2001 at 02:39:08:
I do see your pic clearly. But the mod should be that you connect one end of the resistor to the signal source and the other end to the wipper.About the value of the shunt resistor, you better keep the "total" as 100K same as the original.
After you set the volume pot to your usual listening position, you measure the resistance from the wipper to the ground. Then the shunt resistor value is 100K minus the value you just measured.
Hope this help.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Shunt mod to Volume pot, did I got it?? - Nothing 02:58:20 11/20/01 (5)
- Is this what you mean? - Chuck T 17:57:41 11/20/01 (4)
- Re: Is this what you mean? - Nothing 18:59:17 11/20/01 (3)
- Re: Is this what you mean? - Chuck T 19:46:23 11/20/01 (2)
- Re: Is this what you mean? - Nothing 20:06:21 11/20/01 (1)
- I think I got it. Many thanks. - Chuck T 21:50:49 11/20/01 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
