|
Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ. |
Register / Login
|
In Reply to: "510K resistor as in the diagram near the preamps output jacks" posted by 1973shovel on July 5, 2023 at 08:05:07:
Hi Shovel, your the best! I do have a final couple questions before I get sawing and soldering. I got a CK switch,S series, that is going in like the diagram you sent.The picture shows it lying on the chassis near the rotary switch which I will take out. I have to saw the hole a little bigger for the CK switch. I think I need to see what is in the phono board as the PAS manual has 2 750 caps and 2 27K resistors in the pictorial in the manual. That's why in the picture I was going to install 2 5 point lug strips in case they are important in the new Last PAS. I don't know if they w ere in the circuit.I would of saved them but am a little foggy about where I stowed the old rotary systemOne more question Shovel, When your facing the preamp, Is the top green wire the input to the board and same with the top red wire? I owe you big time and I will make sure I get you back....thanks so much for your time and effort, sincerely Mark K.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: "510K resistor as in the diagram near the preamps output jacks" - mark.korda@myfairpoint.net 09:32:10 07/10/23 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
