|
Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ. |
|
|
|
Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ. |
|
In Reply to: tinned Cu connector: remove or polish the tin? posted by LewinskiH01 on January 20, 2011 at 05:10:54:
from my experience Tin plate is almost neutral when it comes to sonic effect. If you remove it, you then must deal with oxidation, but gain a bit more conductivity. I would definately clean the end where the wire is attached and use solder not crimp.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- tough call - Mike B. 07:36:58 01/20/11 (6)
- RE: tough call - LewinskiH01 14:57:32 01/20/11 (3)
- I don't understand? - moray james 22:36:49 01/20/11 (2)
- RE: I don't understand? - john curl 22:45:39 01/20/11 (1)
- RE: I don't understand? - LewinskiH01 16:52:21 01/21/11 (0)
- I would crimp and solder n/t - reuben 09:02:37 01/20/11 (1)
- RE: I would crimp and solder n/t - john curl 09:04:56 01/20/11 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
