|
Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ. |
|
|
|
Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ. |
|
In Reply to: How do I remove this ribbon cable from circuit board. See picture posted by reb on September 14, 2007 at 05:08:46:
Some of these ribbon connectors are permanently mounted on the board and the ribbon slides into the slot and is locked down using very small tabs on the sides (i.e., the short dimension of the connector body). If you see small tabs there, you can pull them up with your fingernail or Xacto knife and the ribbon will slide out easily. If you try to re-install the ribbon without having the tabs in the open position, it will be very difficult. When the tabs are open, the ribbon slides in nice and easy, then push the tabs back down until they lock. Then you are done.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Check for tab locks!!! - bevo 09:49:19 09/14/07 (1)
- RE: No tab locks, already checked before posting. - reb 10:55:44 09/14/07 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
